This video major introduce pipes
Hello and welcome to the touch screen operation video tutorial, today we are going to talk about pipes. Open the piping element underneath the component and inside the piping underneath the component you will find horizontal piping, vertical piping and elbows. The elbows are the elements that connect the pipes to each other. Let's look at the horizontal pipes first. In the pipe settings you can set the pipe diameter, the thickness of the pipe wall as well as the colour and the direction of the pipe. Look at the flow block properties, the flow block properties inside the flow area settings have the direction of the pipe diameter, that is, the width, the length is the direction of flow, that is, the pipe to set how long, in the flow block settings below the block length, that is, the length of each flow block and the interval between each two flow blocks, can be set by themselves, the flow direction if the horizontal pipe from the left to the right and from the right to the left two The speed can be set as a constant or as a variable, if set as a variable, it is a word address LW0, which indicates the flow direction of the pipe, from -1 to -10 is the reverse flow, when 0 is to stop the flow, from 1 to 10 is the forward flow, LW1 indicates the state of the library, that is, the state of the graphical properties inside the flow block, when LW1 is equal to 0, it indicates the state 0, when 1 is to stop the flow, when 1 is to flow, it is to flow. LW2 indicates the blinking speed, when 0 is not blinking, that is, is always displayed, 1 to 10 control blinking speed, the larger the value, the faster the blinking speed, there is a control condition below, use the condition to control the flow start and stop, if you can not check, then use the flow speed control, suppose I use the LB0 ON, later will simulate Take a look at how this works with the flow velocity above to control the flow of the pipe, flow block properties, dynamic map type, display settings these will not be repeated, click OK after setting. Look at the vertical and horizontal pipeline is also the same, here the same flow rate using the variable LW0 control, and then the condition control flow start-stop LB0 for ON, and then add a connection elbow, elbow is more than one direction, choose the right one can, after setting click OK, and then add a LW0, LW1, LW2 to control the pipeline, plus LB0 control start-stop, and finally click offline simulation The default initial value of LB0 is off, LW0 is 0, the flow block is not flowing at this time, LB0 is set to open, LW0 is set to -5, the flow block will move in the opposite direction at this time, set it to a positive number, it will flow in the positive direction, and the larger the value set, the faster the flow speed. If you add many states, you can change the colour of the flow block by using LW1. LW2 controls the blinking speed, it does not blink when it is 0, and the larger the value from 1 to 10, the faster it blinks.
Get in touch
Please provide us with the information below to complete your request. Just leave your email or phone number in the contact form so we can send you a free quote for our wide range of designs!
Copyright © 2023 Wuxi Mochuan Drives Technology Co.,Ltd 无锡默川传动技术有限公司- www.mochuan-drives.com All Rights Reserved.